A hammer in search of a nail…

Posts tagged ‘Console Table’

Console Table Project

Built a console table to stand behind the sofa in our family room.

The top is of bubinga and was created by joining two boards to create a top that is 15 1/2 inches wide and about 5 1/2 feet long.

The base is fairly simple consisting of four straight legs, an apron around the top, and a small shelf near the bottom. The base is entirely out of poplar. The legs were created from three 3×1 pieces glued and planed to create square legs 2 1/4″ on each side. The apron was attached to the legs via pocket screws as were the supports under the shelf. The shelf was then glued and nailed to the supports.

Here’s a pic after assembly. I haven’t actually attached the top to the base yet, but just laid it on top to get a sense of the final “look” and to show it in it’s eventual spot.

An incomplete and "unfinished" view of the table project.

An incomplete and "unfinished" view of the table project.

The top and base will have different finishes applied, so I don’t want to attach the two until after finishing.  I haven’t decided how to attach the top yet, but I will probably just fix scrap blocks to the inside top of the apron and then screw through these into the top.

Thanks for looking. I’ll post an update once Laura and I get the finish applied.